technician A says that a broken plastic cable in an antenna housing requires replacement of the power antenna assembly

INSTRUCTIONS TO CANDIDATES

ANSWER ALL QUESTIONS

Question 1 Which of these is recommended to help realign the windshield wiper blades? --Masking tape on the windshield

Question 2 All of these may cause wipers to chatter EXCEPT: --improper position.

Question 3 Technician A says that damaged heated seat elements can be repaired. Technician B says that heated seat elements may be bonded to the seat cushion. Who is right? --Both A and B

Question 4 A power window switch is being tested. Technician A says that the switch must be open when testing for continuity. Technician B says that a reading of no continuity indicates a properly operating switch. Who is right? --Neither A nor B

Question 5 Technician A says that the memory seat function will have to be reprogrammed after the battery is disconnected. Technician B says that the memory seat function only works if the vehicle is in NEUTRAL or PARK. Who is right? --Both A and B

Question 6 The memory seat switch will work the seat when the vehicle shift select lever is in: PARK.

Question 7 To determine seat position, memory seat systems use seat position sensors called: potentiometers.

Question 8 Technician A says that wiper arm force on the wind-shield is measured with the arm in the full outwipe position. Technician B says the wiper arm force on the wind-shield is measured with the wiper blade removed from the wiper arm. Who is right? You Answered --B only

Question 9 The horn may be inoperative following an airbag deployment due to a: --damaged clock spring. This study source was downloaded by 100000794933160 from CourseHero.com on 02-26-2022 09:07:30 GMT -06:00 https://www.coursehero.com/file/32107623/PWR01-Post-Testodt/

Question 10 Technician A says that some wiper systems will set a diagnostic trouble code. Technician B says that a faulty control module in a wiper system requires replacement. Who is right? --Both A and B

Question 11 All of these are mechanical failures for a power window EXCEPT: --poor grounds.

Question 12 Technician A says that the depressed park feature is designed to drop the windshield wipers below the lower windshield trim. Technician B says that the depressed park feature requires a separate motor on the windshield wiper assembly. Who is right? --Both A and B

Question 13 Technician A says that a relay sends high current to a power window motor. Technician B says that a relay is used to prevent overloading the power window switch. Who is right? --Both A and B

Question 14 Technician A says that a broken plastic cable in an antenna housing requires replacement of the power antenna assembly. Technician B says that a power antenna motor that shows no continuity must be replaced. Who is right? --Both A and B

Question 15 Technician A says that the rear defogger and heated mirror system operate on the same circuit. Technician B says that a heated mirror heating element can be repaired similar to a rear defogger grid. Who is right? --A only

Question 16 Technician A says that some intermittent wiper systems use a resistor to vary the time between wipes. Technician B says that some intermittent wiper systems use a capacitor to vary the time between wipes. Who is right? --Both A and B

Question 17 A temperature sensitive resistor used to monitor the seat temperature is called a: --thermistor.

Question 18 Which of these is used by a rain sensor to detect moisture? --Infrared beams This study source was downloaded by 100000794933160 from CourseHero.com on 02-26-2022 09:07:30 GMT -06:00 https://www.coursehero.com/file/32107623/PWR01-Post-Testodt/

Question 19 Technician A says that power sliding door problems can be diagnosed with a scan tool. Technician B says that power sliding doors will operate with the vehicle in DRIVE. Who is right? --A only

Question 20 Technician A says that some washer pumps are contained within the washer fluid reservoir. Technician B says that some washer pumps are located outside the washer fluid reservoir. Who is right? --Both A and B

Question 21 The power sliding door initialization procedure: --helps the control module determine the full open and close position.

Question 22 How many steps are contained in the I-CAR Trouble-shooting Flowchart? --5

Question 23 Technician A says that some damaged horn switches require replacing the airbag module. Technician B says that a damaged clockspring harness can be repaired. Who is right? --A only

Question 24 Which of these adhesives are recommended for replacing a bonded side view mirror glass? --Urethane

Question 25 Technician A says that when making resistance measurements on a circuit, it is important to observe the correct polarity when connecting the test leads. Technician B says that resistance measurements should be made using a DVOM set to the Ohms scale. Who is right? --B only

Attachments:

Related Questions

. The fundamental operations of create, read, update, and delete (CRUD) in either Python or Java

CS 340 Milestone One Guidelines and Rubric  Overview: For this assignment, you will implement the fundamental operations of create, read, update,

. Develop a program to emulate a purchase transaction at a retail store. This  program will have two classes, a LineItem class and a Transaction class

Retail Transaction Programming Project  Project Requirements:  Develop a program to emulate a purchase transaction at a retail store. This

. The following program contains five errors. Identify the errors and fix them

7COM1028   Secure Systems Programming   Referral Coursework: Secure

. Accepts the following from a user: Item Name Item Quantity Item Price Allows the user to create a file to store the sales receipt contents

Create a GUI program that:Accepts the following from a user:Item NameItem QuantityItem PriceAllows the user to create a file to store the sales receip

. The final project will encompass developing a web service using a software stack and implementing an industry-standard interface. Regardless of whether you choose to pursue application development goals as a pure developer or as a software engineer

CS 340 Final Project Guidelines and Rubric  Overview The final project will encompass developing a web service using a software stack and impleme